Wire Cleaning Brush

CLEANING

• Step 1: Wear puncture-resistant utility gloves when handling contaminated instruments to avoid injury.
• Step 2: Pre-soak carbide burs in a container of soapy water to loosen debris. Ultrasonic systems may also be used to loosen debris in burs; however, burs should be separated from each other in a bur block during immersion to prevent damage.
• Step 3: Brush away remaining debris using a SS White stainless steel wire brush (Order no. 26040) and rinse burs under running water.
• Step 4: After rinsing, dry burs thoroughly by placing them on absorbent towels. Pat dry all bur surfaces